Why you should “NEVER” use mitts or sponges with Snow-Foam application.

Article by AUTO VALETS:

Snow-foaming a car and then leaving the snow-foam on the vehicle and washing with mitts or sponges is disastrous to your vehicles paintwork. Snow foam is primarily designed as a Pre-Wash Product, that is applied to the whole vehicle and most importantly, left to dwell for up to 5-15 minutes, depending on weather conditions & vehicle condition.

The Snow-Foam is designed to agitate and lift the grit from the vehicle and trap it in the foam during the dwelling period. The mistake many car valeting companies and forecourts make is to use the foam to wash the vehicle thus washing with mitts or sponges that will be full of grit and this is how the swirls are introduced to your paintwork.

SEE IMAGE BELOW

Swirls Introduced by poor valeting standard.

AUTO VALETS use the right Snow-Foam product, allow for the correct dwelling period to do it’s job, only when that process is complete will they remove the grit with a gentle rinse.

NOW YOUR VEHICLE IS READY TO WASH!

AUTO VALETS will now wash your grit free car with a quality AUTO GLYM Shampoo Conditioner to complete the cycle of paint protection for your car, from start to finish, leaving stunning showroom results.

The AUTO GLYM shampoo conditioner is a low foaming solution that contains a water repellent film that causes rinse water to sheet off the surface, helping you to rinse and dry your car faster. Its active ingredients clean your vehicle without stripping away any polish or wax you have previously applied.

Leave a Reply

Your email address will not be published. Required fields are marked *